How to Install a New Water Heater

A water heater is a device that heats water and removes the waste heat that would otherwise be created. The water is usually heated in an unvented system using propane, natural gas, or some kerosene. Southlake Plumbing for this device is part of the heating element itself. Most plumbers will estimate the installation costs for the water heater itself. They may suggest that you get the features they offer for a lower price than the other stores sell them.

water heater

If you are installing your tank water heater yourself, be sure to follow the instructions exactly and do not leave any room for errors. Professional plumbers have been installing tank water heater for years and know exactly what to do. If you decide to install it yourself, you may have trouble locating the correct parts. It is far better to pay more and have the parts arrive at your door than it is to try to install the tank heater yourself and cause further damage. Some plumbers will charge more if they have to go and install the tank and will recommend that you buy the parts that they suggest.

There are also several different types of water heater that you can install. You can have a gas water heater, electric, or propane fueled. Most electric heaters are smaller than the gas models. Installing an electric model can be trickier than the gas models as the wiring for them is different. If you choose to use an electric model, you need to remember that you will need a cord to connect the heating element to the outlet and there are chances that the outlet that the appliance will use can be far away from where you planned to install the water heater.

Before you install your water heater, you need to locate the connection between the hot water tank and the water heater. This connection should be located about six inches above the floor somewhere. It will be far easier to install the heating element if the pipes are not visible. Next, you need to locate the discharge tube. The discharge tube will be located on the inside of the pipes. To find it, you will want to turn down the water valve so that water will flow out of the pipe, and then bend the left and right pipes until you can see the discharge tube.

Next, you will want to close off the water valve. If you have an electric water heater, the water valve will be located on the same side as the tank. If it is a gas model, you will want to close it off near the drain valve. Once both valves are closed, you can begin to install the water heater tank. The tank will be located next to the drain valve and will be held in place by two nuts.

With new water heaters, one of the most important elements to the installation is the drain connections. If the drain connections are not properly connected, leaks will result, and the overall efficiency of the unit will be greatly diminished. The first step in proper drain connection is to determine where the gasket is located. In addition, there will be a drain pipe, and an adjustable drain valve; these will all need to be connected appropriately to the water heater plumbing system.

After the drain connections have been correctly established, you will want to install the hot water heater plumbing lines to their corresponding holes in the drain pan. Once this has been done, you will need to determine which outlet will be connected to the water heater. Most heat exchangers have five to eight outlets. Once this is determined, you can install the hot water plumbing. In many cases, if the hot water heater was connected to an older model, the plumbing may be in good shape, and the only thing you will need to do is install the new hot water plumbing.

Installing a new water heater is a very simple process. The important thing to remember is that, before any work is begun on your water heater, you must disconnect it from the water supply. To do this, simply open the drain valve for a normal water heater, and then attach the hose that leads to the drain pan. You will then close the drain valve for a new water heater.